Spa and Hot Tub Water Treatment & Conditioner Tips
Garden Hose Pre-Filter
Highly recommended & makes initial chemical balancing easier & future issues are greatly reduced. Greatly increases (OFL) Optimum Filter Life of your main filter(s).
Deep clean every 1-2 months using the Filter-Soak following the directions on bottle. Rinse filter(s) weekly or as needed.
Ozonators – Highly Recommended
Compatible with the all natural Water Treatment & Conditioner.
Sweep these areas out as water will turn cool and may produce a slight odor.
Wash in hot water without soap and double rinse to remove dyes and any soap residue.
All jets including neck jets, waterfalls, etc., should remain open slightly so that water may flow freely during filtration cycle.
Spa covers and headrests should be cleaned if any odors are present.
*If you have drained your spa and expect to leave it drained for an extended period of time, you may want to ‘shock’ the water with chlorine when you refill.
Bacteria, water mold, and algae can grow in your spa lines during shut down, and this ‘shocking’ should eliminate any contamination. 1/2-oz for spas up to 250 gallons / 1-oz for spas up to 500 gallons.
_Before testing your water always run pumps on high for at least 1-minute for better accuracy.
Water Temperature Range – 90 degrees or higher.
pH level – 7.8 – 8.2 / Alkalinity – 80 – 120
_Our Water Treatment & Conditioner helps stabilize at these levels.
_See Hamilton Index for more information on proper hot tub water balance.
Total Hardness – 200 – 400ppm
_If hard water, use a Stain & Scale control (Defender).
_If low calcium hardness (under 200ppm), use a Calcium Increaser.
Minimum (6-8) hrs per day. 24-7 filtration is recommended if capable.
If your source water is hard water and you have not used a garden hose pre-filter, then the recommended amount of a Stain & Scale control (Defender), should be used weekly, following directions on bottle. Also a Metal Out product may be used when filling spa.